17 November 2020
A few hours in the garage this evening. Tidying up the rust that dropped off my subframe during dismantling, and generally clearing away tools just to give myself room. I spoke to Dave at Canems earlier today, to confirm the list of connections he needed, I went through the loom and cut them out, ready to send to Canems so they can build my new engine loom. Had to move a things around so I could get my engine hoist into place and then I jacked up the front subframe and put it on axle stands. I removed the wheels, then I attached the hoist to the gearbox and removed the bell-housing bolts. I separated the gearbox from the engine and lowered it to the floor. I removed the clutch cover and friction plate and found the cause of the noisy spigot bearing, it was completely dry and falling apart. Finally this evening I undid the engine mounting bolts and lifted the engine off the subframe.
0 Comments
Leave a Reply. |
Archives
January 2021
Categories |